Scuba Regulator Maintenance - Best Recommendations onHow to maintain your Regulator Your scuba diving regulator is crucial part of scuba gears, it is your lifeline below the surface. A failure in some other scuba equipment can mean a bad dive, yet a failure affecting your scuba regulator is often deadly.
Below are some diving regulator maintenance pointers that can have your scuba regulator operational properly for many years to come, and also have you diving secure and care free.
-Get rid of Water From the Dustcap and Seal the Scuba diving regulator
If you are going to be rinsing your regulator while it's off the tank, you need to make sure no water gets in the second stage. First, make sure the dustcap is free of water. A technique to do that is to blow the water off with air from your tank. Alternatively, you should use a towel to dry the surface of the dustcap. Next securely fasten the dustcap over the opening. Be sure to have a proper seal as you don't want any water to get in the first stage of the scuba regulator.
-Immerse The Scuba regulator into Fresh Water
If you simply do one thing in your diving regulator care routine, make it be this step. This is a critical step and will eliminate any deposits that may be in your scuba diving regulator. Swoosh the scuba diving regulator around a lttle bit to remove any loose particles. Dive centers usually have a very good rinse tank you can use following a dive to clean your gear. If you aren't at a shop, soak your regulator the moment you get a chance.
Work any levers/buttons back and forth to release anything that might have attached to your equipment. Do that while the scuba regulator is submerged. But, you should definitely do not push the purge button. This will let water into the second stage which could travel up to the first stage. Something you do not want to occur.
-Flush With Fresh Water
While you will almost certainly get nearly all of the debris from the regulator with the above trick, if you get a chance, run a stream of water through the 1st and second stages (again, with the dust cap firmly in place and without pushing the purge button). This should remove any remaining particles in the chambers and other openings.
-Dry the Regulator
Let the regulator drip dry for a few minutes or until thoroughly dry. But, don't dry in direct sunlight or someplace hot, this could affect rubber parts which could cause the scuba regulator not to work as it should be on your next dive.
-Store inside a Safe Place
Store your regulator in an area which is cool and try. Make sure that it's not in any position where the regulator hoses are kinked and away form harmful fumes and direct sunlight.
Annual Diving regulator Service
A large amount scuba regulator makers require the scuba diving regulator to get serviced yearly in order to stay under warranty. Check the conditions on your scuba diving regulator. While this action have been subject to debate, it is probably the most secure thing to do.
Hopefully you will agree with me that scuba regulator maintenance is pretty easy. Just go by this guide and you should have a lot of wonderful and safe dives ahead of you.
Go to the link to read additional posts on
diving regulator and also
regulator rviews. I also write a web site on
dive regulator reviews, here you can discover indept reviews, video tutorials and strategies on how to locate the best diving regulator .